on 02-11-2011 5:21 AM
Hi All,
I have created the MIP fro the materaial in which
i maintained the MIC with reference to the batch
characteristic. In all the MICs, maintained the
following values
1. in the control indicator Optional Characteristic
is ticked
2. in the misc, removed the tick mark for Reocord
measured values
3. MICs are the Quantitative means with lower and
upper values.
4. Some MICs have min. value from 0.000
Now the requirement is, some MICs does not required
to be valuated during the result recording, for
this i maintained the above settings but still
system ask me to maintain the values for these MICs
and also the system not picking up 0.000 when enter
the value in the result recording.
Does I miss anything apart from this for the above
requirement, your valuable advise will highly
appreciated.
Thanks,
Hrishi
1.system will not ask for recording result as it is optional char.
2.but if u go in result tab then depending upon valuation mode, it is ask u for valuation
3. system will not allow u to enter value 0.000 because u have removed the tick mark for Reocord
measured values. even if u put this tick on u have to maintain decimal place as 4 in order to record values like 0.0000
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please check the Valuation mode settings in sampling procedure you assigned to the respective MIC.
Thanks & Regards
Rajendran
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.