How planning version can be intialized?

[Former Member]

How planning version can be intialized?

Am not getting product and location in /SAPAPO/SDP94

above error is coming in slection.

Best luck

[aparna_ranganathan · Accepted solution]

Are you talking about planning area initialization ? Try /sapapo/ts_parea_initialize and then run /sapapo/ts_lcm_cons_check in repair mode (se38). These two should definitely solve your problem

Thanks

Aparna

[former_member220487 · Accepted solution]

Hi Girish,

As suggested by Aparna, run

1) /sapapo/ts_parea_initialize

2) /sapapo/ts_lcm_cons_check

Repeat step 2 if you observe any inconsistency in the log. The log should show all green (when no inconsistency).

Hope this helps.

Regards,

Nawanit

[Former Member · Accepted solution]

Thanx, Aparna

[Former Member]

Girish,

Sounds like you are jumping the gun a bit. You have to set up DP and SNP before you can use any planning books.

To initialize a planning version. /SAPAPO/MSDP_ADMIN. Your MPOS must already be active. Then, select your planning area, right click. If you have no Time Series objects, you will see a menu "Initialize Planning Version". If you have any time series object, you will instead see "create time series object". Executing either one of these will initialize the planning version and the planning area. When you are done, you should have a green light on the Planning Area.

There are a number of steps besides this one that must be performed before you can use your planning books. I suggest you take a look at Best Practices Configuration guide, which will describe the necessary steps.

Demand Planning

http://help.sap.com/bp_scmv250/BBLibrary/Documentation/DPL_BB_ConfigGuide_EN_DE.doc

Supply Network Planning

http://help.sap.com/bp_scmv250/BBLibrary/Documentation/B06_BB_ConfigGuide_EN_DE.doc

Best Regards,

DB49