Set phase "data transfer" to "not active"

[Former Member]

We have a TDTIM which has finished all it's sub-steps under phase "data transfer" (i.e. all sub-steps are green).

However the phase "data transfer" itself is still a "active phase".

In my previous TDMS project, this never happened.

In table cnvmbtstate, no way to set it manually.

Could you please share your experience?

Thanks!

[Sandeep_Kumar · Accepted solution]

That should not happen if all sub-activities and cumulative activities are completed successfully , in cnvbmtstate you can check for dat transfer phase for the sepcific package and find out if there are activities which are still not executed or ended with errors.

[Former Member · Accepted solution]

We've made sure that for all sub-activities under phase "data transfer" have status "finished" in cnvmbtstate.

But phase "data transfer" is still a "active phase". Therefore postprocessing cannot be executed.

I never had this in my previous TDMS project.

Is that any other table where I can set above phase to "finished"?

Thanks!

[Former Member · Accepted solution]

Hi Have you tried changing the current phase in CNVMBTACTIVE?

[Former Member · Accepted solution]

Hello CC122010,

If you have solved this problem I would be grateful if you can share the solution.

Regards,

Abhijeet

Got it ! It is saved in table CNVMBTACTIVE. Thanks!

Edited by: abhijeet more on Feb 16, 2011 4:28 PM

[Former Member]

Hi abhijeet,

in  CNVMBTACTIVE table it not allow me to edit the table, may i know the step to update this?

regards

Laila

[rajesh_kumar2]

Use the t-code ==> CNVMBTACTIVE.

[Former Member]

Hi Rajesh,

Thank you for your prompt respond. however using the t-code CNVMBTACTIVE it cause the selected  package is deactivated, not 'Data Transfer' phase only in that particular package. Please advise.

regards

nurlailah  

[rajesh_kumar2]

Hi nurlailah ,

I did not understand your requirement.

Why do you want to change a de-activated package ?

I would better suggest you to open a message with SAP to safely validate your package and help

switch the active phase if really required.

Thanks,
Rajesh