NWDI Configuration Wizard.

[Former Member]

I am currently following the steps in the "Configure NWDI in MII" and I am getting an error message in the initial stage of the installation.

I have navigated to http://<server>:<port>/nwa/cfg-wizard and I have clicked on Initial setup of functional unit SLD.

I selected typical configuration and entered my pwds.

I selected Setup a new local SLD server and used my server as the ObjectServerName

It fails after I press Next. the following is the error...

Error: Notification

Error: Connect to message server host failed

Connect_PM TYPE=B MSHOST=dixon.apex.ray.com GROUP=RPD R3NAME=RPD MSSERV=sapmsRPD PCS=1

ERROR service '?' unknown

TIME Wed Jan 26 10:26:35 201

RELEASE 711

COMPONENT NI (network interface)

VERSION 39

RC -3

DETAIL NiErrSet

COUNTER 2

Step: Create group SAP_SLD_DATA_SUPPLIER

Retry StepSkip StepCancel Process

What is wrong with the configuration or what should I be looking at to correct this?

[ErvinSzolke · Accepted solution]

Hi,

I belive this has no NWDI relation so far.

I think you need to ask around in a different forum what is wrong when accessing the message server:

Error: Connect to message server host failed

Connect_PM TYPE=B MSHOST=dixon.apex.ray.com GROUP=RPD R3NAME=RPD MSSERV=sapmsRPD PCS=1

Best Regards,

Ervin

[Former Member · Accepted solution]

I believe you are correct. However, I do not know where to start so I believe the NWDI forum is a good starting point.

[Former Member]

Do you have an entry with sapmsRPD in your services file?

Kind regards,

Mark

[bernd_speckmann]

Yes, you should check your services file for sapmsRPD. If it is a windows installation you can find it under %windir%\system32\drivers\etc...

There should be an entry sapmsRPD with 36<xx>/tcp. <xx> is the instance number.

Regards