message control of CJ class

[Former Member]

Hello guys,

is it and how is it posible to modify message control of certain messages from CJ class?

Thanks guys.

Laimonas

[Former Member]

I got feedback from SAP support:

"Message CJ526 is hard-coded as 'Warning' message type"

so... thank you for your efforts. Your feedback will be useful in my other cases,.

[Former Member]

Hi,

Not sure but Check tcodes OBA5 or OBMSG. Remember that this is a cross client table and modifying a message can affect other modules using the same message class.

Regads,

Gokul

[Former Member]

yep, I checked those before.

and CJ option is not included.

Looking forward to hearing more suggestions.

Laimonas

Edited by: Laimonas Bindokaitis on Jan 25, 2011 9:05 AM

[Former Member]

Hi,

Check in tcode SE91. Put message class as CJ and click on display. Modifying the message will be cross client effect. So be careful..

Hope it helps.

Regards,

Gokul

Edited by: Gokul Pillai on Jan 25, 2011 3:27 PM

[Former Member]

I can modify the syntax there, but not behaviour. Or maybe I am wrong here ? I don't want to modify syntax, I want make it from worning to error.

Laimonas

[Former Member]

Hi,

I would not recommend doing that since these are system messages. If you are sure that this change wont impact any of the other modules where this message class is being used you can do it.

Regards,

Gokul

[Former Member]

it is simple case. CJ526 . I want it in error. Nobody will be harmed.

So - you still think it can be done in se91 ?

[Former Member]

No it is not possible to change the message CJ526

Praveen

[Former Member]

ok, thanks praveen.

Who else stands for "imposible" ?

[Former Member]

Hi,

Try the following;

Goto OBMSG, click on new entries and add application area CJ. Then select the application area and double click on messages on rightside. Input new entries with application area as CJ and select message 526.

Here you can set the output type as E for error.

Remember that this a cross-client configuration.

Regards,

Kabir

[Former Member]

I did configuration as you suggested.

But I don't get my error while testing the result .

maybe I need to recompile something somewhere ?

[Former Member]

Hi,

Add the CJ526 message for CJ application area in OBA5 and then check.

Regards,

Kabir

[Former Member]

I already did that before. And it didn't help. more ideas please .