BD54 not allowing to delete logical system

[Former Member]

Hi,

We did system refersh from Prod to Quality and further we found that while starting BDLS it was not allowing to do so. We got message like <Target> logical system already existing . Further checks revealed that in BD54 that our quality system's logical client entry was already there which would normally come after running BDLS post DB refresh activity for System refresh). Because of this issue we are unable to dlete the quality entry in BD54 and to further start our BDLS acitivty.

Please to confirm us as we are stuck.

Thanks & Regards,

Ashish Robinson

SAP BASIS Support

[Former Member]

Hi,

The issue is that our qulaity systems's logical client enrty was already there before refresh on our Production server (from where this refresh was done).

Now after refresh this whole of BD54 is now same on our quality server as was on our Prod server so the logical client entry of qualitya slo came in B%$ on qulaity server.

We get message as :

Diagnosis

The logical system STQCLNT002 is still used in distribution model FI.MD.COPY (client 002).

System response

The deletion cannot be carried out.

Procedure

Confirm that the logical system STQCLNT002 is really no longer used. Delete it first from distribution model FI.MD.COPY (client 002), then delete it here.

Please note that just pressing enter key does not work at all.

Regards,

Ashish Robinson

[Former Member]

check the below link. it might gives you some clue

[Former Member]

Hi,

Try this:

1. Open the system and client (SE06 and SCC4) for manual changes.

2. Run BD54 and delete QA entry (save in new TR if prompts)

3. Run BDLS to convert PRD-->QA logical system names.

4. Check BD64 to see the distribution model

5. Run WE20/WE21 to adjust logical port/partner profiles.

Thanks,

Subrata

[Former Member]

Hi Ashish,

Since you made the coy from PRd client, the QAS client has "no changes allowed" as like in PRd. change the client settings and try to delete the entry in BD54. It may help.

Regards

Raj

[Former Member]

Hi ,

Thanks all. I resolved my issue.

Solution:

1) Removed quality system RFC "STQCLNT002" from SM59 just to b sure nothing was blocking

2) Also entry of STQCLNT002 needs to be removed from BD97.

3) Further if you try to use ENTER when you try to delete entry inBD54 of quality it won't allow ,how many time you may try pressing enter to get away with the warning message. So solution here is to further double clieck on that warning message (in BD54) and see where its blocking . It will show you some method where its blocking .

4) To locate the method use txn BD64 and scan through the entires to get to the affected link (here it was STQCLNT002).

5) Be careful, do not delete the entry of STQCLNT002 itseld but actually the corresponding leaves of the methos needs only to be removed to over come the blocking in BD54 (where we wanted to remove the entry of STQCLNT002).

6) Now goto BD54 and and you can easily remove entry of STQCLNT002.

7)Now BDLS would easily start.

Regards,

Ashish Robinson

Please grant me point if you find the answer useful. It surely did work for me absolutely fine.

[Former Member]

After the Message hit Enter and you should be able to run BDLS.

Hope this helps.

Thanks,

Naveed

[Former Member]

what the error which you are facing?