on 01-07-2011 9:04 AM
Dear friends,
I want to give only target value in MIC. When results recording deviates from this value then system should give error in valuation field. Is it possible?
Regards
Prashant Atri
Any more replies....
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
The target value does not come into play with regard to valuation unless you are using a tolerance key. In either case, the valuation is based on the upper and lower specs. So if your target value is 10, then you must set the upper spec to 10 and the lower spec to 10 if there is to be no variation from the target.
FF
Hi,
In SPRO >quality management> Basic setting-->Maintain setting at plant level
Here select your plant click on detail.
Then in next screen in result record tab you have option Recording confugaration where ou can select autamatic close so in this case if result deviate then system will show you pop up window with default rejected radio button on but again here you can clicjk accepetd and valuate.
Or check with other option close,nevigate, save autamatically.
check and revert back.
regards
SANI>L
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
107 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.