Problem after LSMW uploading inspection plans

[Former Member]

Hi experts,

I have used LSMW upload inspection plans to materials, when going back to check after importing, the Sample Procedure in inspection characteristics is in disabled status, and nothing inside.

Consequently, when inspection lot is generated, SAP assigned Full Inspection to all inspection lots.

Can anyone help on this?

Many thanks!

Regards,

Daniel

[Former Member · Accepted solution]

While uploading the sampling procedure you have to make sure that "sampling procedure ' is ticked in the control indicator for the MIC's.(This will allow you to enter the sampling procedure during upload & will not become Grey)

[lakshmi_prasad7 · Accepted solution]

try to bapi

[Former Member · Accepted solution]

Hi SujitSND,

Would you mind informing where can I check the control indicator is ticked for sampling procedure?

Many thanks!

Regards,

Daniel

[Former Member · Accepted solution]

select that characteristics and click on Control indicator' tab

we will see Sampling Procedure' indicator there.

[kiran_kumar179 · Accepted solution]

Dear as said above it will be in characteristics there you can see control indicator tab so you need to assign that control indicator field in LSMW project check with your ABAP guy.

Cheers

KK