Why CHIPS's wiring is not retaining ??

[Former Member]

Hi Folks,

I have developed 2 WD components with CHIPS and connected with the inports of second CHIP with the Outport of the First Chip.

In the Configuration Mode, I am unable to set the Connection Between 2 CHIPS.

While running the application, I am able to set the connection b/w the chips and which is working for my User ID only.

For others, these connection properties are not reflecting.

What I need to do, In order to maintain these Connection Properties for all the Users..???

Regards,

Aneel Danda

[Former Member]

>

> Hi Folks,
> 
> I have developed 2 WD components with CHIPS and connected with the inports of second CHIP with the Outport of the First Chip.
> 
> In the Configuration Mode, I am unable to set the Connection Between 2 CHIPS.
> While running the application, I am able to set the connection b/w the chips and which is working for my User ID only.
> For others, these connection properties are not reflecting.
> 
> What I need to do, In order to maintain these Connection Properties for all the Users..???
> 
> Regards,
> Aneel Danda

Hi Aneel,

probably you already know that.

Runtime if you make changes then it is user personalization and that is the reason it is not working for all other users. You can try doing a administrator personalization.

You can also try page builder to connect the two chips .

[Former Member]

Thanks for Your Reply...Baskaran.

This Wiring is not working when I am trying for Side Panel.

In Admin Mode, For the Side Panel...It is not allowing me to Mapping b/w the Ports.

But in Normal, I am able to change/give the Connection.

Any Idea on This...!!!

Edited by: danda aneel on Jan 4, 2011 1:09 PM