Number range for trans./event type WL in year 2011 does not exist

[deepak_dave2]

Hi All,

I saved the delivery and picked the material.While posting post good issue i am getting this error.

Number range for trans./event type WL in year 2011 does not exist

Message no. M7562

And cannot proceed. I went to wl which is accounting material good issue document and there year and number range is maintained.

Please help.

Regards

Deepak

[jignesh_mehta3 · Accepted solution]

Hello Deepak,

This is a general error that people get in the begining of the New Calander Year. Refer to the Thread below & your issue will be solved to your satisfaction:

Hope this helps,

Thanks,

Jignesh Mehta

[deepak_dave2]

Thanks issue resolved

Deepak

[Former Member]

Hi Deepak,

I have face the same problem as you, however could not resolve it... Could you share briefly how did you do it?

Thanks,

Skruzdeliukas

[Former Member]

two transactions codes you need to enter

1.OBA7

2.OMBT

[Former Member]

MAINTAIN THE NUMBER RANGES FOR THE ABOVE TRANSACTIONS CODES

[Former Member]

This message was moderated.

[Former Member]

maintain number ranges in OMBT for WL

[Former Member]

hi

please have a look at this notes on calendars.

370236.

balajia

[former_member217082]

Hi Deepak

Go to OBA7 and select the transaction event type WL and maintain number range for the year 2011.

Thanks and Regards

Srinath

[former_member211108]

Hi Deepak,

Check/assign the number range in T code OMBT . After that carry out the new cycle to test the effect.

Hope this will help you.

Please revert back to forum in case of any doubts.

Regards,

Atul