on 12-22-2010 1:43 AM
Hi,
2 usage has maintaind in one Insapection plan with different counter. but the system did't caluculate the sample size.
Pls advice to get this.
Regards,
KB
go to qa02 , enter inspection lot, check whether insp plan is attached. if not then attach it by clicking on task list assignment tab and then go to sample tab and click on sample calculation tab.
save and check
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
rather it has calculated full lot quantity as sample quantity.
Dear what sampling procedure you are using it depends on the sampling procedure and did you assign the sampling procudure to inspection characteristic in inspection plan?
Also check In material master Inspection setup remove the 100% inspection tick if it is enabled.
Cheers
KK
User | Count |
---|---|
100 | |
11 | |
11 | |
6 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.