on 12-17-2010 5:23 PM
We have a sender and a receiver that are both nonunicode. We have no intention to convert to unicode.
So we leave the DataCodepage=blank in export_monitor_cmd.properties?
If not blank, what the the code for EN and DE?
Thanks!
In most cases there is No need to change the default value for Data code page.
Also see SAP Note 552464,Possible values: 4102, 4103, 1100
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks!!
However, this is from the guide called: Distribution Monitor (version 1.8.1)
Usersu2019 Guide
4.2 Setting code page information for System Copy of Non-Unicode systems without conversion to Unicode
The DM can also be used for system copies of Non-Unicode systems without conversion to Unicode. In this case it is mandatory to set the preparation mode options dataCodepage and dbCodepage. The value depends on the content of table TCPDB. If the table contains multiple entries or if it contains a single entry with an ambiguous blended code page, then both options need to be set to u2018MDMPu2019. Otherwise both options need to be set to the code page number listed in TCPDB.
My TCPDB has only one entry:1100.
Please help. Thanks!
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.