on 12-14-2010 1:41 PM
Hi All,
I am using ECC 6.0 with EHP4.
I did set up a internal number range in engineering change management.
When I create a 'ECR' and save it. I get a message "Change number XXXXX0001 created"
But when I go to CC02 or CC03, and check for the above number, I can not access it.
Gives a error message "Change number XXXXX0001 does not exist".
Any idea, where exactly could be the problem. Useful answer will be rewarded.
Thanks
Vardhan
Hello Vardhan
is there update terminate raising after that? please check if any record in SM13 or ST22 regarding it. I guess there might be some inconsistancy between the table entries and corresponding number range settings.
Regards,
Jane
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
102 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.