on 12-14-2010 8:54 AM
Hi All,
I am executing Stability Study cycle in QM. I have completed initial testing, then scheduling as well as result recording & UD against scheduled inspection lots. But now I am stuck with one issue:
When I check "Display Stability History", I am getting tab for Initial Test along with one tab for each assigned conditions. But here issue is, under Initial Test tab I can see all characteristics results while for under other tabs (condition tabs) system shows only first characteristic result. Here please note that I have used same Inspection Plan and even result recorded and valuation done (all accepted) is same for initial inspection lot as well as scheduled inspection lots for conditions.
I am unable to understand why system is showing All Characteristics results under Initial Test tab but only first characteristic is shown under Condition tabs.
Hope to get some help from all you gurus there.
Thanking you in advance.
Devang
Edited by: Devang Shah on Dec 14, 2010 2:57 PM
If you create the inspection characteristic directly in inspection plan, system shows only first characteristic at stability study history.
I think there is 'bug' in SAP standard function module 'QSTH_STABI_HISTORY'.
If you want to use SAP standard function module, you should assign 'master' inspection characteristic in inspection plan.
or
You can copy and modify SAP standard function module and assign it to action box item in configuration.
Regards
Luke
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
95 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.