PI 7.1- Message going thru Integration Engine

[Former Member]

Scenario:

ECC<-----SoapAdapter(Synch)

---

> PI7.11 <

---

JDBCAdapter(Synch)--

---

>OracleDatabase

Use of Local Processing required in this project.

I've successfully completed Design work and then completed Integrated Configuration (all those tabs, Inbound processing, Receiver, Receiver Interfaces, Outbound Processing look correct)

Then I did the ABAP backend communication on the ECC side

(SM59-RFC Destination to point to AAE,

then SXMIF - defined Sender Interface,

then sxmb_adm - IE Engine Config.-->Specific Config where I added IS_URL.

Ran my test from ECC. It is still going thru IE engine and cannot find receiver.

What am I doing wrong? Please advise...

[Former Member]

Hi,

Hope you have created RFC destination of TYPE G...

Also did you associated the sender id created in the subparamter of the IS_URL Runtime parameter...

these parameters IS_URL should be multiple one for IE other for scenario specific...

HTH

Rajesh

[Former Member]

I did.

In SXMSIF, I only created a sender ID (named it, RECONREPORT) where I

Left Agency and Schema blank

Party and Service: put *

Request - Put my Sender Interface and Sender namespace

Then in SXMB_ADM-->Specific config.

I created a new entry of

Catogery: Runtime

Parameters: IS_URL

Subparameter: I copied the text of Sender ID from SXMSIF and pasted it.

Current value: dest://AAE_PEH

on a different note, in SM59 I have

RFC Destination: AAE_PEH

Target host: put my java host

Service no: put my java port here.

[Former Member]

Closing this!