Cannot assign deilivery to Shipment

[Former Member]

Dear all,

In VT01N, i can't assign deilivery to shipment.

It just shows message:

Number of deliveries found: 0

Message no. VW852

I've checked Maintain transportation relevance for delivery types and Maintain transportation relevance for delivery item types.

So, what's problem?

Thanks& Best Regards,

Quanglv

[Former Member · Accepted solution]

Hi Quanglv,

In delivery doc. level (vl02n), you must check whether the Picking and WM status should be C (fully). If it is not after picking and confirmation of your transfer order from LT03 and LT12 (confirmation, please try to add your delivery to your shipment document again.

I hope it will work on it.

Regards,

Sinan

[Former Member]

Hi le,

Please check whether tou have made the route relevant for transportation.

Please check if the route is determined in the delivery.

The trans planning status in the Delivery doc trans Tab should be A or B then only the delivery will appear while creating shipment.

Regards

Mayank

[rajiv_trivedi]

Hi Mayank,

I have same issue & could not find delivery document number while creating shipment cost. The trans status is C, Picking status is C and WM status is also C. I refreshed and also tried after few hours but my delivery is not appearin. Route is well defined with delivery type, item category. I shall appreciate if you trhow more light what area we are missing....Thanks

[Lakshmipathi]

Once you execute VT01N and after clicking the "Deliveries" tab on top left, a box will appear. Here under the tab "Delivery status", by default some value will flow. Maintain blank field here and execute.

thanks

G. Lakshmipathi

[former_member696369]

Hi,

Check once Route has been maintained or not at delivery, transport tab.

[Former Member]

hi,

this is to inform you that,

what system saying is right because it is triggering from the Include LV50LF15.

please check have you done total configuration for transportation module.

please check and come back

balajia