on 11-24-2010 3:51 PM
Hi everyone
I know that I can use the AC 5.3 Configurator Validator to review my AC 5.3 configuration. But I need to load the standard set of tests to perfrom the review.
Can anyone tell me where I get the standard set of tests from, as I have it installed, but no tests are visble in the "Select Checks" screen even when I click on the filter.
I am using AC 5.3 SP13.
Thanks
Simon
Hi Simon,
I doubt that the issue is with the authorization. Have you gone through SAP Note # 1370400
Read the deployment section, which says:
The user who is accessing this site must have UME action "AC.ViewACValidator". This should be included in one of the user's roles to allow access for that particular user.
If the user has access, ensure that all the steps are followed properly.
This should address the issue.
Good day!
Best Regards,
Raghu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.