Modify results QE02 when lot inspection is UD done

[Former Member]

Hi gurus,

Is possible to modify a lot inspection results (QE02) when UD is done? System shows a message of status and not allow it.

Mark the indicator Long Term Characteristics in MIC (QS23) is a possibility but I think is not correct to use this field for it. My MIC are optionals and I should mark this indicator in all of them... I don't see clear...

Any ideas?

I will revvard all answers!!

Thank you!

[kiran_kumar179 · Accepted solution]

Dear it is not possible to change the results after UD has been done.

But check this in sand box and revert.

1. In the MIC set the 'Optional Characteristic' and 'Long tem inspection ' in the control indiactors.

2. Attach MIC in inspection Plan

3. Do results recording and comlpete UD. all short term charactericts are closed.

4. QA12Change UD with history for Inspection Lot ,

Menu-> Reset inspection completion -> Status changes to LTIN

5. Goto QA02 --> you woudl see " do you wnat to compete Long term inspections" --> yes

6. Then Long term inspection characterictic is open for results recording.

7. Change and complete results --> Make UD

Cheers

KK

[Former Member · Accepted solution]

Hi..

Got it that is not possible to change the result after UD has been taken,

But can you pls tell me how can i do as you asked optinal adding MIC if batch no. is Diff against that Insp Lot??

Regards,

Abhishek