on 11-16-2010 5:20 AM
Dear all
as i create process order in system inspection lot is created for in process inspection (03 origin), but this lot is not being displayed in the QA16 transaction as i want to do collective UD for these lots
in MIC Optional Indicator in checked, instead of Required
What else i need to do to get lots in QA16
is there any option or t code to do the mass changes in the control indicators of MIC
Dear check the inspection lot selection criteria like code group,Plant etc.
Cheers
KK
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear check this below points.
1. Check if Material Master Auto usage decision has been checked.
2.All characteristics should be optional if not make all the char as "Optional " through control indicator This can be done through next lots only.
3.All chracteristics must be calculated and status should be 5 completed and no defect recording done.
4. Check mic indicator activated in material master and you have to do RR for this inspection lot or u can force fully complete all MICs and check in QA16
5.Did you selected releavant UD selected set for inspection origin 03.
Cheers
KK
Dear did you check the points which i given in my last reply?
I think you have activated MIC indicator in MM QM view for 03 origin so you have to do RR for same lots if you don't want to do
RR then forcefully close all MICs for each lot in QA11 make lot status as INSP then all lots will be appeared in QA16.
Check and Revert.
Cheers
KK
Check
QA40 & QA41
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
11 | |
10 | |
6 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.