on 11-11-2010 4:19 AM
Hello Folks,
We are on SCM 5.1.
Attempting to realign two characteristics in one step - it is erroring out with the message " Realignment of Complex Generated Selections is not possible"
Is there a way to do this as there are many reocords and splitting them would be quite a manual task.
Appreciate any help on this!
Cheers.
Hi Liz,
Realignment does not support more than one characteristic realignment in a single step. It have to be broken down into multiple steps.
I would suggest developing a custom ABAP Code to populate the table, so that it can be used in the long run as well.
Hope this helps.
Thanks
Mani Suresh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Liz.
For SCM 5.0 , there was a technical restriction on size of the generated table.
The size of the generated realignment and copy table and therefore the number of characteristics in these tables are restricted . This is a general technical restriction of a DB-table in which a line can not exceed an estimated total of around 2000 characters
I am not sure if this applies to your case.
Trying a smaller data set mey help to check.
Regards
Datta
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
7 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.