Initial status Adapters restarting a system after system copy

[Former Member]

Hello,

We have executed a PI system copy. Before making the copy we have stopped the sender adapters in the communication channel monitoring in order to avoid processing of message immediatly after bringing up the new system.

After executing de copy and starting the new copied system all adapters are started in an active state! We should expect the status to be in the same state as of the moment of creating the copy. The logging shows "automatic intial start". How can we retain the status of the adapters in the same state as when creating the copy.

Thanks in advance.

Emile

[nikhil_bose]

I guess the communication channels must be 'Disabled' before taking the backup. As far as I know, the conditions specified in the communication channels make an adapter active state.

[Former Member]

The status of the adapter at the moment of sutting down the system should remain the same.

We have seen it before when making copies.

It seems to be there is a parameter at startup that controls the initialization of adapters when starting up the system. But where to find and configure this parameter??

Regards,

Emile