on 10-26-2010 8:57 AM
Dear experts,
I've this problem:
I've create an inspection lot without task list.
If I try to assing a task list the system give me the message "No inspection plan could be found".
But in transaction QP02 I've seen that the inspection plan exists and the material is assinged to the insepction plan correctly.
Where's the error?
Hi,
Kindly check below points
1. Inspection Plan has been released
2. Inspection Plan Header check quantity field Vs the Inspection lot Quantity. If your Quantity maintained is greater than the Inspection lot QTY you will get the same error.
3.You are using the Correct Key date.
Regards
Nitin
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Most of the issues for a plan not being assigned have been raised here already. I suggest you rereview the value in QA02 to see what usage the lot is looking for. Than change the key date to one day after the date the inspection plan was created and assigned to the material.
Once you have double checked all the above, go to QA02 and click on the button to assign the specifications/plan and see if the lot is updated.
If not, please tell us:
1) what is the inspection type and origin for this lot.
2) what are that statuses of the lot at this time.
That might help us.
FF
1) Compare date: MAPL-DATUV (insp. plan valid from) and QALS-GUELTIGAB (insp. lot key date)
The valid from date should be equal or smaller than insp. lot key date.
2) Compare quantities: PLKO-LOSBS (max lot size) and QALS-LOSMENGE (ins. lot quantity)
The max lot size should be equal or larger than insp. lot quantity.
3) Check MAPL-LIFNR (vendor restriction on insp. plan)
If any value exist, QALS-LIFNR (vendor) should be equal.
Regards
Luke
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Make sure that "Date of creation of task list must be prior to that of date of creation of inspection plan.
Have been said that ,go to qa02>inspections specs->change the date here to "prior or equal to date of creation of task list"-->click on inspec specs & click on sample.
I hope you can get it
Also make sure that task list is realeased & Usage is same.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Can you chk the key date in Inspection plan and inspection lot it should be same.
Regards
GK.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
9 | |
8 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.