on 10-19-2010 12:35 PM
Hi Expert:
There is a a manually created lot ,and the UD is made.How can i change the batch number?
I don't want to cancle the lot.
Best reagrds!
Dear,
In this case you can do this with material to material transfer with same material number. MB1B use movement type 309 and change the reciving material batch number. Else use the User exit QEVA0008. With this user exit u can reset the UD
Please Refer the note 175842.
Regards,
R.Brahmankar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Since this is a manually created inspection lot, no material movements will help you.
In fact, nothing will help you. Since the UD is already made, you can't change anything about the inspection lot. Sorry.
All you can do is go in to QA11 and document that the lot was incorrectly created.
Create a new manual lot for the batch you want.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear try this use MB1B movement type 311 where the sending and receiving storage loactions are the same. You can set the receiving batch during the posting.
Check and Revert.
Cheers
KK
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.