on 10-09-2010 10:34 AM
Dear Experts,
User wants to record the data like supplier test certificate number, supplier lot number, conductivity mentioned by supplplier etc., during the inspection. There may be max two values for each of the above.
Please suggest the suitable solution for this sceneriaos. (Inspection type 01)(Bstch Management is not active)
Thanks,
Sachin
Hii,
Use the Inspection point to capture this info. In Inspection point u can activate maximum of 6 fields.
2 fields - alpha numeric (Conductivity)
2 fields - numeric fields (Supplier info)
1 - Date
1 - Time.
Supplier lot no nothing but Inspection lot no. Test certifcate no can be config in Q-Info Record for Supplier else u maintain this has one feild in Inspction point.
Define freely defined inspection points in spro. Goto QCCO>Quality planning>Insp plng>genreal>Define Insp point for identifier. Here define above info and save. After creation assign Inspection point in Inspction plan at Header level.
Now on RR for each inspection lot, system pop up Inspction point screen where u can enter these info. Check table QAPP for relevant info.
Edited by: Lokesh K on Oct 9, 2010 3:49 PM
Edited by: Lokesh K on Oct 9, 2010 3:56 PM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
There could be one more option.
Make MIC's of said requirements.Attach class char to them.When you will do results recording enter the respective values.
say You want to enter Certificate number then create a class char numerical with single value
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.