on 10-08-2010 9:40 PM
Is is possible to get a UPC and EAN assigned to one material? Can the both be added to the BOM and/or how can correct one be chosen during production?
Any advise?
G
Hello
Assuming you have defined an EAN (EAN Category = 'HE' = Manufacturer EAN) for the material in the "Basic Data 1" view then you can assign the UPC within the "Additional Data -> Units of Measure".
Assumption: Base UoM is CS (= Case).
Then you define a ratio of 1CS : 1CS an assign the UPC (NUMTYP = 'UC').
However, I cannot tell you if and how the UPC can be dragged into the BOM.
Regards
Uwe
PS: Obviously it is possible, too, to use the UPC in "Basic Data 1" and assign the EAN within "Units of Measure".
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.