on 10-08-2010 7:27 AM
Hi Gurus,
I'm performing Solution Manager E2E configuration.
In Basic configuration--> Diagnotic Setup I'm getting the following error.
Please suggest the solution. Pleasse check the below error.
ABAP/Solution Manager connection test failed : A failure occured while connecting to ABAP stack on xs05093sap sys=01 client=001 user=DDIC. Details : Connect to SAP gateway failed
Connect_PM TYPE=A ASHOST=xs05093sap SYSNR=01 GWHOST=xs05093sap GWSERV=sapgw01 PCS=1
LOCATION CPIC (TCP/IP) on local host with Unicode
ERROR partner '10.130.103.2:sapgw01' not reached
TIME Fri Oct 8 07:46:48 201
RELEASE 701
COMPONENT NI (network interface)
VERSION 38
RC -10
MODULE nixxi.cpp
LINE 2835
DETAIL NiPConnect2
SYSTEM CALL connect
ERRNO 111
ERRNO TEXT Connection refused
COUNTER 1
- ABAP/UME User store connection test failed : A failure occured while connecting to ABAP stack on xs05093sap sys=01 client=100 user=xakbnine. Details : Connect to SAP gateway failed
Connect_PM TYPE=A ASHOST=xs05093sap SYSNR=01 GWHOST=xs05093sap GWSERV=sapgw01 PCS=1
LOCATION CPIC (TCP/IP) on local host with Unicode
ERROR partner '10.130.103.2:sapgw01' not reached
TIME Fri Oct 8 07:46:48 201
RELEASE 701
COMPONENT NI (network interface)
VERSION 38
RC -10
MODULE nixxi.cpp
LINE 2835
DETAIL NiPConnect2
SYSTEM CALL connect
ERRNO 111
ERRNO TEXT Connection refused
COUNTER 2
- ABAP/BW connection test failed : A failure occured while connecting to ABAP stack on xs05093sap sys=01 client=001 user=DDIC. Details : Connect to SAP gateway failed
Connect_PM TYPE=A ASHOST=xs05093sap SYSNR=01 GWHOST=xs05093sap GWSERV=sapgw01 PCS=1
LOCATION CPIC (TCP/IP) on local host with Unicode
ERROR partner '10.130.103.2:sapgw01' not reached
TIME Fri Oct 8 07:46:48 201
RELEASE 701
COMPONENT NI (network interface)
VERSION 38
RC -10
MODULE nixxi.cpp
LINE 2835
DETAIL NiPConnect2
SYSTEM CALL connect
ERRNO 111
ERRNO TEXT Connection refused
COUNTER 3
Regards,
Ravi.
Check this note and reply the results.
Number 1008474
Short text Diagnostics Setup Wizard uses wrong ABAP client
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi There
You are getting this error cause the solman_setup >> Initial Config is not fully done , also you have to confirm
about your BI client detail in the solman system.
Would advise you to first finish the all steps of Initial config and other earlier steps in basic config.
Best Regards
Jai Wardhna
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.