10-07-2010 3:11 PM
Hi All ,
If I want to create the DeviceSerial Numbers Internally means where I can define the Number ranges for the Devices . And also I have an requirement to create new MR reason for Simulation Pls provide in IMG where we can defien the MR reasons or else its an SAP std. Pls clarify .
Thanks ,
Harry,
10-07-2010 4:55 PM
Hi Harry,
For number range, please refer to Olivia's suggestion.
For MR Reason, I didn't find any IMG to define a new MR reasons. However, If you still want to add a new MR reason, you can use transaction SM30 and maintain table TE609 to add new a MR reason.
Regards,
Chaiphon
10-07-2010 3:26 PM
Hi Harry,
Please see the following regarding the device serial no's:
SPRO ->
SAP Utilities
Device Management
Installation
Basic Settings
Define Number Ranges for Device Group and Define Number Ranges for
Logical Numbers of Devices....
If you see the explaination for Defining Number Ranges for Logical
Numbers of Devices you will see that it says because the logical device
number is used internally, you should not create number ranges with
external number assignment.
During the creation of devices the table MASE is used as a kind of
number range object (the next higher possible serial number per material
is sued) If necessary you can influence the equipment numbers by using the number
range object EQUIP_NR - equipments. But for device serial numbers there
is no number range object.
Alternatively...
You can use function module EXIT_SAPLIPW1_008 from enhancement
IQSM0008 when you create a material serial number and equipment. This
means that every time you create a device, the corresponding combination
of material and serial number undergoes further user-defined checks.
In relation to the MRR I will have a look at get back to you...
Hope this is helpful for you.
Regards
Olivia
10-08-2010 8:55 AM
HI Olivia ,
Thanks for your reply .... But as per my understandin the Logical DeviceNumber has been generated at the time of the Device fitted in to the Installation( pls correct my understanding if its wrong) & I need whilst creation of Device Number in IQ01 .
Thnaks & Regards ,
Harry.
10-08-2010 3:15 PM
Hi Hariharan,
When you do the technical installation thats where the device number is created.
thanks,
VR
10-07-2010 4:55 PM
Hi Harry,
For number range, please refer to Olivia's suggestion.
For MR Reason, I didn't find any IMG to define a new MR reasons. However, If you still want to add a new MR reason, you can use transaction SM30 and maintain table TE609 to add new a MR reason.
Regards,
Chaiphon
10-08-2010 8:52 AM
Hi Chaipon ,
Thanks for your reply on Meter reading reason .....It would be greatful if you give some more inputs in addition to olivias suggestion on creation of DeviceSerial Number .
Thanks ,
Harry.