on 10-07-2010 5:07 AM
Hi Guys,
I am doing EHP4 upgrade for an ABAP only system
During the CHECKS module error occured in the phase PREP_GENCHECKS/JOB_RSUPGRCHECK_PRE!
Last error code set : RFC_error 2: Dump Error.
I check the status of the BG job RSUPGRCHECK is being cancelled in SM37 with Dump " SYNTAX_ERROR"
erroe in program " SAPLSDMA"
object deltab does not have a component called " mainobjex".
I implemented note as a 0001449201 as per req.
I am on kernal 32.
Should i upgrade my kernal?
Regards
Abhishek
Hi,
I am on kernal 32.
Should i upgrade my kernal?
It is always recommended to update KERNEL and R3TOOLS (R3trans, R3check, R3load etc) before start upgrade...
It eliminates many errors...
Regards.
Rajesh Narkhede
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Abhishek,
Did the note 1449201 implement sucessfully ?
Please ensure it was the latest version (version 24) of the note that is implmeneted as changes were made to the note with each version. You need to ensure the latest version is applied.
As per the note:
Make sure that you note the manual prerequisites.If these are required
in your system, you may not under any circumstances implement this note
without adjusting the structure DDGENTAB. Otherwise, syntax errors would
occur in the report RADMASUTC and then Dictionary activation would no
longer be possible.
If errors occur when you implement the correction instructions or when
you perform the manual pre-implementation steps, open a message under
the component BC-DWB-DIC and refer to this note. Allow SAP Support to
have access to your system.
In this case it may be best to have the object checked and corrected by BC-DWB-DIC team.
Regards,
Paul
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Could you please paste TOOLIMPD.ELG logs here ?
Thanks
Sunny
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
78 | |
9 | |
9 | |
7 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.