How to find out the destination of an "Adaptive RFC Model - DEPRECATED"

[former_member182534]

Hi All,

How to find out the destination of an "Adaptive RFC Model - DEPRECATED" of an running application

and Where is the destination created in the server .

I have got the code of the running project from NWDI .

Thanks in Advance

Regards

Piyas Kumar

[ErvinSzolke · Accepted solution]

Hi,

I am not sure I fully understand the question, but as per the guide

http://www.sdn.sap.com/irj/scn/index?rid=/library/uuid/50f7192d-2808-2d10-189b-df3fa5f71abf

Excerpt from Page 7

-

---

Caveat Confector!1

ARFC1 destinations were created using the Web Dynpro Content Administrator tool. This tool is

still available for compatibility reasons, but the destinations it creates are not used by ARFC2

models!

Instead, you should use the u201CDestinationsu201D tool found on the Configuration Management screen of

the NetWeaver Administrator.

-

---

Therefore I think if you look up the application in the WD content Admin, there you can find out what kind of JCO/RFC connections are belonging to it. You can find it on http://<host>:<port>/webdynpro/dispatcher/sap.com/tc_wdtools/Explorer

Browse your application here, and then select the JCO Connections tab on the right hand side.

I hope this helps.

Best Regards,

Ervin

[former_member182534]

Thank a lot for the quick reply the solution provide is the exact thing which i was looking for

Thnaks

Piyas Kumar Das

[p330068]

Hi Piyas,

As Ervin said, you need to check the JCO destinations used for Adaptive RFC Model in the Content Administration >> Webdynpro >>Maintain JCO destinations in the SAP Potral.

Refer to and for similar discussions.

Hope it will helps

Regards

Arun Jaiswal