10-06-2010 8:06 AM
Hallo Retail Expert,
The Scenario is as follow,
I have some Articles that I order by vendors only in defined Quantity,
for ex. 3, 6, 9, 12 or 5, 10, 15 or 12, 24, 36 Pieces. For this purpose
I am using Rounding Profile and I have defined regarding my requirement.
It Works really good when I work with Variants. When I create Purchase
Orders per IDOCs it works fine because there I use only Variants. But
when I try to create Purchase order manual in TA: ME21N with Generic
Article, there this Rounding Profile (Quantity Addition/Subtraction
profiles) doesnu2019t work. There comes a Pop-up with all the Variants,
where I gave my required quantity. At that point this examination
doesnu2019t work. It work only when I work with variants.
I am assigning rounding profile in Article Master at Purchasing View
Level (Article/Vendor/Purch.Org).
I cannot use Standard (Unit of measure is the order unit) because Piece on Inbound Delivery.
Could you please suggest me why at Generic Article level it doesnu2019t
work?
Is there any other possibility in Retail?
Any suggestion is Welcome.
Thank you in advance.
Regards,
Nilesh
03-11-2014 12:44 PM
Hi,
I am also facing the same question from my User.
Have you got a solution for the generic article?
03-11-2014 12:57 PM
Hi all,
as far as I know, the rounding functionality is not performed on the generic article. The rounding profile is considered only when the variants are entered directly in the PO. This is standard behaviour.
I cannot give the reason for this logic implemented. Maybe it would be a possibility to make an enhancement in the PO?
Regards
Tobias