on 10-04-2010 5:52 PM
Dear All,
I am loading the data from dso to the cube through DTP. The problem is that some records are getting added through data
packet 1 to the cube around 50 crore records while through data packet2 records are not getting added.
It is full load from dso to cube.
I have tried deleting the request and executing DTP but again the same no of records get added to the cube through datapacket 1 and after that records are not added to the cube through datapacket 1 ;request remains in yellow state only.
Please suggest .
Nidhuk,
Is it an ordinary transformation which you have between the DSO and CUBE ? or did you do something with the start/end or expert routine.
did you check the system log SM21 and ST22 to see if there are any messages during your load ?
/MiB
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Nidhuk,
Data load transfers package by package. Your story sounds like it got stuck in second package or something. Suggest you check package size, try to increase to a higher number to see if anything changes ? 50 records per package kind of low, your load should not spread out into too many packages.
Regards. Jen
Edited by: Jen Yakimoto on Oct 8, 2010 1:45 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
83 | |
24 | |
12 | |
9 | |
7 | |
6 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.