Data partly after horizon 01.05.2007 to 01.11.2012

[Former Member]

Hello Experts,

In background job when we check the log we found an message "Data partly after horizon 01.05.2007 to 01.11.2012"

Time Series for PA is created from 01.05.2007 to 31.10.2012.

Is this issue with the storage bucket profile settings OR with time series ?

Please let me know what has to be done ?

Regards

Rahul Chitte

[Former Member · Accepted solution]

Hey hi

Thses are standard SAP reports which related to Time series consistency check.

As per the SAP best practice, we should have following reports regularly in production system.

In our case we are running these reports daily on Production system.

Thanks

Amol

[Former Member]

Hi

As I mentioned above you execute the above reports which will create additional time series which are less than your planning horizion.

/SAPAPO/TS_LCM_PAREA_UPDATE

/SAPAPO/TS_LCM_PLOB_DELTA_SYNC

/SAPAPO/TS_PAREA_INITIALIZE

Please execute these, I think it should help you.

Amol

[Former Member]

Hello Dear,

Thank you very much for writing in.

I hope it wont be a problem by executing the above reports in the production system.

I am bit afraid to execute them; please write back in; that it wont hamper anything in system ..

Regards

Rahul Chitte

[Former Member]

Hi Rahul,

Please check the sap notes 632768, 628582 whether applicable

to your scenario

Regards,

R. Senthil Mareeswaran.

[Former Member]

Hello Senthil,

Thank you very much for psoting.

I just found a [link |; in SDN which has the similar issue ..

It refers to amend the storage bucket profile & Time series .. any relvance I can make it out ?

Please write back

Regards

Rahul Chitte

[Former Member]

Hello Senthil,

I did checked the notes mentioned by you in above post, but they are all for 3.0 & 4.0 but we are on 5.0.

So the notes do not help us ..

Regards

Rahul Chitte

[Former Member]

Hi

I think you have longer planning horizon than your planning stram calendar.

Please execute the following report to fix the following issue.

/SAPAPO/TS_LCM_CONS_CHECK

/SAPAPO/TS_LCM_PAREA_UPDATE

/SAPAPO/TS_LCM_PLOB_DELTA_SYNC

/SAPAPO/TS_PAREA_INITIALIZE

Thanks

Amol