on 08-25-2010 10:33 PM
Hi All,
Below is the SAP informational message.
The number I am assigning is not currently in the internal number
range.
The warehouse is assigned to an external number range.
External assignment of numbers from an internal number range not
allowed
Message no. L3212
Diagnosis
The external storage unit number to be issued is in an internal
number range.
Procedure
Unlike other applications, external number ranges in the WM
system are not explicitly defined. Instead, they are taken from
the unused numbers in the internal number ranges when the "Issue
type" switch in the Customizing application allows external
numbers to be issued for the warehouse number.
Hi Arup
Please be informed the situation with the storage unit number
range is as follows:
Unlike in other application within the SAP-system you can't really
create an external number range. All storage unit number ranges are
internal as far as the WM-application is concerned. If you define an
external storage unit number range it is considered to be the number
range of another warehouse.
Please refer to note 14881 (release independent) :
"The "external" indicator in the number range definition is ignored. The
check is performed for all the number ranges defined.
The only external numbers that are accepted are those that do not appear
in a number range."
If you intend to take over the SU number assigned externally,
the SU number might be in the range of the internal number and this
is not allowed and because of this, you will get the error message
L3212. Also I've attached note 63720 for additional information.
Hope the above information helps.
Please also check attached note 565557.
FYI:
If you want to use external number ranges for the storage unit number
in WM - external - means that you can use numbers that are out of the
defined internal number range and that you do not define it. For example
if you want to use the number range 11 - 20 as an external number range
and all 1 to 10 as internal then you define only the internal number
range. The external number range in WM must not be defined also not
as an external number range. This is a bit different from other areas
where external number ranges are defined.
Regards,
Ramana
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
I have not set the HU identification to external. Its is still an internal assignment.
Config for HU Management - External Identification - Number Range maintainence for HU Identification.
This is the location where I have maintained the number interval for HU and I have not set the external identification check box.
However the system still complains about the external number assignment when I go to confirm the TO for an outbound delivery or create a TO using I/b delivery.
Any help is appreciated. Are there some other configurations that I need to look into?
P.S: I did look at the OSS notes mentioned above.
Thanks,
Arup
Please read OSS note 14881.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
110 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.