on 08-24-2010 5:16 AM
Hi
we have an "IDOC flat file" we need to process and convert into an XML file in PI 7.11 in the File Sender adapter. My challenge is when using this user-module as described in William's [blog|http://www.sdn.sap.com/irj/scn/weblogs?blog=/pub/wlg/13743] [original link is broken] [original link is broken] [original link is broken]; I am wondering what should the settings be in the "Content Conversion" tab? Do we need any settings at all?
Thx in advance
Hello Bohamo,
You do not need any content conversion parameters for this. The Idoc module shipped by SAP will take care of everything.
Hope this helps.
regards,
Gaurav.
Edited by: Kr.gaurav on Aug 24, 2010 6:41 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Bohama,
There is no need to provide any content conversion paramters, as the Module Processor shipped along with the IDOC will take care of everything.
Refer the below link:
http://help.sap.com/saphelp_nwpi711/helpdata/en/b5/bd93642dd3410f90ebea702399fac4/frameset.htm
Thanks,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Don't use File Content Conversion.
Regards,
Prateek
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.