Message processing error

[Former Member]

Hi

I am doing an Idoc to File. The same Idoc is triggered to two receiving interfaces, which are both File. I copied the message from the Test tab of Message Mapping in IR and pasted in Runtime work Bench , Integratioon Engine test message tab.

I get a message " Scheduled for outbound processing " for both my receiver interfaces.

How do I figure out the errror ?

Regards

[Former Member · Accepted solution]

Hi Ajith,

Please check whether the messages are stuck in queues.

Use SMQ2 transaction.

-Supriya.

[Former Member · Accepted solution]

Hi

Issue resolved. The error message was blocking the queue and once I unchecked " Maintain Order at Runtime " both started working fine

Regards

[former_member208856]

I hope you have 2 receiver determinations, each for 1 file system,

But in this scenario, you have to use only 1 receiver determination & give the conditions for receiver, if there is no condition for receiver, leave blank condition part.

[Former Member]

Hi Ajith,

Are you using the different conditions in the receiver determination?

If yes, then please check those conditions.

-Supriya.

[Former Member]

Hi Supriya

I am not at all using any condition in Receiver Determination. The same Idoc should be sent to both interfaces. So there is no need of any conditions

Regards