on 08-16-2010 2:44 PM
Hello,
I m trying to have just one group code in the Usage Decision matchcode. Is it possible ?
(To limit the users choice and quick selection)
Thanks a lot in advance everybody for your answer
Regards , Philippe
If you are seeing all the codes, it measn you haven't defined the UD codes to the inspection type.
In config:
QM>Quality Inspection>Inspection Lot Creation--->Maintain Inspection types
For each inspection type, enter the UD selected set to be used. If you tick on the "Selected Set in Same Plant" than you must create the selected set for each plant the inspection type is to be use in. This allows each plant to have their own list of codes unique to their plant.
For most inspection types however, you can usually just create a selected set in a master data plant and use that.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.