SAP_XI_IDOC/IDOCXmlToFlatConvertor fails with Enhanced Idoc

[Former Member]

Hi All ,

We have used the PI conversion module SAP_XI_IDOC/IDOCXmlToFlatConvertor in a number of Idoc-To-FlatFile scenarios and it is working fine.

However recently we tried to use it in a scenario where the target file structure is that of an enhanced Idoc.

In this case, the receiver channel (where the module is configured) fails with the error message, Idoc metadata not available in ECC.

We have tried the following:

1) Checked NWA connection for RFC Destination and JCA connection factory : Working fine.

2) Loading Enhanced IDoc in IDX2: Working Fine.

3) Change the receiver agreement to point to a Standard IDoc instead: Working fine.

Have any of you been facing the same issue and/or could you guide us to a possible solution.

Thanks,

Abid Ali

[Former Member]

Hi Ali,

We are also facing exactly the same issue with a custom IDoc while converting on the receiver side.

It is actually interesting that the module "SAP_XI_IDOC/IDOCFlatToXmlConvertor" works fine for the very same idoc and fails to recongize the metadata information while converting from Xml to Flat.

Did you have any luck in getting this resolved?If so,can you please provide the details.

Thanks

Narendra