on 07-07-2006 3:30 PM
Hi,
I am doing File to IDOC scenario. I have done all configurations in IR and in ID. But it is throwing error like ATTRIBUTE_IDOC_METADATA-Basic type ZOIDOC does not exist.
Where as my custom idoc is a not exit in metadata (IDX2). Also I am trying to reload same manually but I am not able to reload it. I have all required configuration in SAP R/3 side like partner profile.
I would appreciate yours inputs.
Hi Sunil,
You are saying that you are unable to load the Metadata even manually.
There could be a problem with the RFC destination defined within the IDX1 port. So first test the RFC destination using SM59.
Also ensure that you have used the right naming conventions for the PORTS and RFC destinations as below:
<SID>CL<ClientNo> e.g DXXCL055 where DXX is the SID and 055 is the Client No.
Rgds
RC
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Prakash,
Thanks for your inputs.
All segments are released properly.
--Sunil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Sunil
Go to IDX2 transaction. Then select your IDOC and delete it. Then once again run your scenario so that the new Metadata will once again load into it.
---Satish
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sunil,
Go to IDX2 in XI system and import the Idoc. If it exists,delete it and Reload.
Also make sure that,IDX1 entry is correct.
If you are in PI 7.0 then you can try this-
http://help.sap.com/saphelp_nw04/helpdata/en/44/11982eb8da648fe10000000a1553f7/frameset.htm
Regards,
Moorthy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
81 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.