MM-SUS Scenario: MM PO data transfered to SUS but SUS PO creation is fail

[Former Member]

Hello All,

In case of MM-SUS scenario, when i created a MM PO and idoc data was sent to SUS, but in SUS transaction SXI_MONITOR i found that the line is scheduled instead of successfully status. In SMQ2 i found the error message: Storage form of product ID not yet defined in Cust omizing. As i know that in MM-SUS scenario, the material master is not needed to maintain in SUS. Please advise how to handle this trouble, thanks,

Best Regard

Joseph Chen

[Former Member · Accepted solution]

Hi Joseph,

In SPRO go to settings and IMG

Cross-Application Components ->SAP Product->Basic Settings->Define Output Format and Storage Form of Product IDs.

maintain this settings simmilar to settings in your SRM system.

Thanks,

-Devi Swain

[Former Member · Accepted solution]

Hi Devi Swain,

Firstly thanks for your reply.

i have setted this configuration as you mentioned, and Prod.ID Lenth = 18, "Display leading zeros" and "save lexicographically" are not ticked. Then the new error message show:Prod.ID Lenth is longer than the customized setting.

By the way, MM material number lenth = 18

Best Regard

Joseph Chen

[Former Member · Accepted solution]

HI, Joseph Chen:

I think you should decheck the settings between SUS and ERP system .

the lenth is 18 ,that is right .

[Former Member · Accepted solution]

Hi Joseph,

Please check/tick the first 2 box - "Display leading zeros" and "save lexicographically" and uncheck the last box "Leading Zeros for Internal No. Assignment".

It should work.

Thanks,

-Devi Swain

[Former Member · Accepted solution]

Hello Devi,

Your proposal is effective to fix this problem, thanks very much.

Joseph Chen