RSTOTL00 program obselete in ECC 6

[Former Member]

Hi all,

We have a system which has been recently been upgraded to ECC6.In the previous versions we had this program RSTOTL00 which used to run the job SAP_WORKLOAD_COLLECTOR.But in the new system the job is failing since the program is not available.So from the ECC 6 systems dont we need this job running.Thanks.

[Former Member · Accepted solution]

Hello Ambarish

> We have a system which has been recently been upgraded to ECC6.In the previous versions we had this program RSTOTL00 which used to run the job SAP_WORKLOAD_COLLECTOR.But in the new system the job is failing since the program is not available.So from the ECC 6 systems dont we need this job running.

correct. RSTOTL00 was only available for the releases 46C and 6* ([note 945279|http://service.sap.com/sap/support/notes/945279]). The workload collector was completely redesigned in release 7x so RSTOTL00 is not used in this release any longer. Simply ensure that the new workload collector report SWNCCOLL is included in table TCOLL.

@prateek_y:

> it depends on you how frequent you would like to make it run usually default it shud run per hour.

Not usually! As SAP_COLLECTOR_FOR_PERFMONITOR starts reports based on table TCOLL it has to be started each hour, otherwise you risk that some of the reports in TCOLL will not be started at all...

Regards, Michael

[Former Member · Accepted solution]

Hi,

Thanks all.The report has been scheduled in 000 client.

[Former Member]

Hi Ambrish,

After the upgrade you need to schedule new job which has been changed compared to your last one.

New Job: SAP_COLLECTOR_FOR_PERFMONITOR which needs to be scheduled in 000 client and should run under DDIC or a user equilvalent to it. Also pls make sure you run this on correct time as sometimes it fails if its running at odd times e.g. 06:03:01 instead use clear time (no fraction of seconds and all) 06:00:00 and it depends on you how frequent you would like to make it run usually default it shud run per hour.

Goto SM36 >>Standard Jobs>> SAP Component = BC and then you can release the jobs as per your requireemnts.

More Info on what you need to run in your new system as Housekeeping jobs you can visit the below link.

http://help.sap.com/saphelp_nwce711core/helpdata/en/c4/3a7ede505211d189550000e829fbbd/content.htm

More information on new architecture of SAP_COLLECTOR_FOR_PERFMONITOR.

Note 1300273 - SAP_COLLECTOR_FOR_PERFMONITOR: New architecture as of 7.20

[JPReyes]

I think you need to schedule SAP_COLLECTOR_FOR_PERFMONITOR instead.

What version of SAP did you upgrade from?

Also check SAP Note 16083 and make sure all the standard reorg jobs are scheduled

Regards

Juan