SPAM/SAINT update issue before and after EHP4

[Former Member]

We tried to update the SPAM/SAINT package after the installation of ECC 6.0 EHP4 Ready system.

Here are few steps which we have performed on the system even before EHP4 installation.

1. we tried to update the SPAM before moving with EHP4 installation however it did not completed and when logs seems to be proper. We reset the queue with Function Module OCS_RESET_QUEUE using Tx se37 .

2. The spam status went to green with updated version

3.We moved ahead with the EHP4 installation assuming that installation will fix the SPAM issue. After the installation completed the SPAM status was green with the new version , however when we exectuted the import spam/saint it again went to the PROLOGUE state.

Please let us know if we can use the system productively as we have performed these steps without the SAP support , also there are no errors at the ST22 other than originated by the spam tx.

Please find the attached trans log

http://s000.tinyupload.com/index.php?file_id=66042159519595351356

http://s000.tinyupload.com/index.php?file_id=20880680182063159483

Please advice....

Also , the show buffer command shows following output..

D:\usr\sap\GCQ\SYS\exe\uc\NTAMD64>tp showbuffer GCQ pf=
hostname\sapmnt\t

rans\bin\TP_DOMAIN_GCQ.PFL tag=SPAM

This is tp version 375.94.95 (release 701, unicode enabled)

GCQ buffer:

SAPKD70139 | | |has already been imported completely

.

that makes 0 transports to be imported.

tp finished with return code: 0

meaning:

Everything OK

Edited by: indian tiger on Jul 14, 2010 3:03 PM

[sunny_pahuja2]

Hi,

> 1. we tried to update the SPAM before moving with EHP4 installation however it did not completed and when logs seems to >be proper. We reset the queue with Function Module OCS_RESET_QUEUE using Tx se37 .

This is not supported by SAP.

As I understand you are installing new EHP4 system, then what do you mean by before moving to EHP4 installation ?

> 2. The spam status went to green with updated version

> 3.We moved ahead with the EHP4 installation assuming that installation will fix the SPAM issue. After the installation >completed the SPAM status was green with the new version , however when we exectuted the import spam/saint it again >went to the PROLOGUE state.

>

As I can see your buffer status which is showing that transport is already imported then why are you importing same SPAM status again.

What is your current SPAM level and which SPAM level you are trying to update ?

What is the system status now ? Is upgrade completed successfully. Please provide all information.

Thanks

Sunny

[Former Member]

Hi Sunny ,

I meant that we first installed EHP4 ready system and then performed EHP4 installation using EHPi tool .

After the installation of EHP4 ready system we updated the kernel and SPAM/SAINT version , While doing the SPAM/SAINT update which was running from a long day we restarted update again in an attempt to update it , however we were unable to reset the SPAM/SAINT update status using the mentioned Table.

After this the SPAM/SAINT status was green and version was update done 7.01/39

After that we moved further with EHP4 installation using EHPi tool which went fine...after the installation of EHP4 we just checked in curiosity and started the SPAM/SAINT again ...now the status is red ( PROLOGUE) and its just going through Execution of reports phase.

[sunny_pahuja2]

I would suggest you to open a call with SAP support and let them analyze your system.

Thanks

Sunny