<Trace level="1" type="T">-no interface action for sender or receiver found

[Former Member]

Hi Experts,

I try to integrate PI and abap 7.0 using XI adapter (feel doubts about type).

RWB and SXMB_MONI at PI side show that test message was successfully sent. But I cant see it in DQ

http://cnh.com/XI/SDIIOC01/RCVR</Trace>;

<Trace level="1" type="T">--no interface action for sender or receiver found</Trace>

<Trace level="1" type="T">Hence set action to DEL</Trace>

<Trace level="1" type="B" name="CL_XMS_MAIN-PERSIST_READ_MESSAGE" />

<Trace level="1" type

What could be the problem which I'm facing and how could I fix this

regards

nagendra

[Former Member]

Hi,

Please check the thread given below:

[Former Member]

i understood its ur SAP XI to inbound proxy scenario?

Do the message in MONI of XI is showing correctly?

R u getting an error message in R3 moni?

Did u configure ur scenario correctly both at Xi n R3 using sproxy tcode.

chirag

[Former Member]

hi chirag

yes,in sxmb_moni in xi it is showing success,but uin r3 side it showing green flag.

[Former Member]

If u r getting an error in Moni of R3 then the staatus flag should be red.

Where r u getting that error message.

can u check the queues using smq1/smq2 tcode at R3 end. green flag means it is scheduled for processing.

chirag

Edited by: Chirag Gohil on Jul 7, 2010 5:31 PM

[Former Member]

Hi chirag,

i am not getting error,i am getting green flag in sxmb_moni in r3.when i checked in in trace i am getting the above message and also i am debugging it manually it will be gettin sucessful in moni r3 side

[Former Member]

did u checked the queues at R3? there might be chances that other messages are stuck in queues.

chirag

[Former Member]

yes, i checked in r3 queue,there is no msg in in smq2.it is showing ZERO MSG.