Wily host agent

[Former Member]

Hello,

Could you please advice how is it possible to install and potentionaly configure host agent for Wily EM without using remote installation via SMD? I can see in Wily inst. guide only notice to remove EPAgent and activate hostAgent via SMD wizard (since SMD SP13). At the moment I can see only data from Introscope java agent and no data from host-level agent like Garbage collection frequency and duration etc...

Thx a lot in advance

[Former Member]

Dear Julius,

I forget one important information :

Wily Host-Level Introscope Agent (ABAP) replaces the EPAgent (Environment Performance Agent).

Best regards

Pascal Cuennet

[Former Member]

Hello Pascal,

Thank you for your reply. However I am interested in how could I (if even) install host agent without SMD as this is not in place in out enviroment at the moment.

Thanks

Julius

[Former Member]

Dear Julius,

Yes, both Wily IS Agent have to be deployed using SMD.

1. You install the ISAgent (ISAGENTSMD8SP01_00-10007435.SCA for example) in Solution Manager ONLY.

You do not have to install it on any managed systems !

2. Using SOLMAN_SETUP procedure guided :

2.1. Initial Configuration is done ...

2.2. Basic Configuration is done ...

2.3. Start the Managed System Configuration

In 3rd phase of the SOLMAN_SETUP guided procedure, you have "Wily Introscope Configuration" steps.

Here, you have the activity "Configure Wily Introscope Agent".

When we talk about Wily ISAgent, it includes 2 agents :

1. Wily Introscope Java Agent which monitors all applictions on JAVA level.

2. Wily Host-Level Introscope Agent (ABAP)

Hope it helps ?

Best regards

Pascal Cuennet

Why do we have 2 Wily IS Agent :

1.