cancel
Showing results for 
Search instead for 
Did you mean: 

Decimal places for MIC

Former Member
0 Kudos

Hi all

I have to change the no. of decimals for a specific MIC.I have done it for the MIC in QS23 and expect the same to get reflected in the quality plan where this is being used which is not happening.

Is there something I am missing?

Please suggest.

S Anil

Accepted Solutions (0)

Answers (2)

Answers (2)

Former Member
0 Kudos

Also you have to Tick on " Replace MIC" at client level in customization.

former_member42743
Active Contributor
0 Kudos

This will only work if the MIC was created as a REFERENCE MIC and you did not unlock the characteristic in the inspection plan to change the spec ranges. If it is a copy model or incomplete copy model, then you have to change the number of decimals in the inspection plans.

FF