on 06-25-2010 1:34 PM
hi all,
please point out all post installation steps for sap content server.
actually m already installed content server and configure content categoty and repository.
after these steps waht i can do.
please point out post installation steps for sap content server.
Regards
VIVS
main qus. is answered
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hope this helps(Pg 27 onwards)
Regards,
Pradeepkumar Haragoldavar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Vivek,
Once content server is installed you need to go to OAC0 and OACT to define content reporitory. Also in OAC0 you need to set fileds for contetn reporitory like area as Document management system etc. You need to define IP address and port here.
After this go to CSADMIN and activate the certificate for the same. Unless and until you activate the certificate the content server will not wiork for DMS.
I hope this will resolve the query.
Regards,
Ravindra
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
first of all thanks to u both for ur reply....
i am already done all these things, after OAC0, OACT and CSADMIN configuration, whats steps are reamaining?
means after Content Server installation, OAC0, OACT and CSADMIN configuration, what steps are necessary....
Edited by: viveksingh on Jun 30, 2010 11:16 AM
If you have followed all the steps indicated in the installation procedure guide(Transactions STRUST,SM59,SMICM,SICF and the ones indicated above), then proceed to verify your installed Content Server using the Internet Explorer Browser
http://IP-of-Windows-server:Port/ContentServer/ContentServer.dll?serverInfo
P.S.hope its a troublefree setup.Good luck:)
Regards,
Pradeepkumar Haragoldavar
hello all
i am facing problem in data carrier creation actually i am creating data carrier type PC and i want set as default for all desktop
after DEFINE DATA CARRIER TYPE SERVER, FRONT END and Select PC and IDENTIFY FRONT END COMPUTER its shows
No entries found that match selection criteria
Message no. SV004
Diagnosis
No entries were found when importing data from the data base.
Procedure
If you have specified selection conditions, start the transaction again with conditions that are less restricted.
You can make new entries independently of this. To do this, select the function New entries in menu Edit.
help me
User | Count |
---|---|
110 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.