on 06-23-2010 12:56 PM
Dear Gurus
While doing the results recording defect class is coming automatically when the value recorded, is greater or less than the upper limit or the lower limit , as well as the valuation tick or cross according to the values recorded is coming properly but where is the setting so that we can choose our own defect class to appear while doing the RR
Regards
Sandip Sarkar
The defect class is assigned to the catalog codes in QS42 when you create them.
The defect classes are set up in configuration:
QM>Quality planning>Basic Data>Catalog>Define Defect Classes
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Sir
Thank you for answering but there are so many defect classes why the system is choosing a particular defect class all the time and how the system is comparing the upper and lower limits with the recorded value and also giving the tick when the recorded value falls within the limits and cross when the recorded value is outside the limits there must be some setting
Regards
Sandip Sarkar
The defect that is used is determined by the characteristic. In the control indicators there is an indicator to record defects. If this is set on for the characteristic, than defects will be recorded anytime the valuation type being used for the characteristic determines that the valuation is reject. In the characteristic, under catalogs, you define the defect catalog to be used and if you are using automatic defects recording, you also define here the specific code to used when the characteristic is rejected.
I hope that all makes sense.
FF
User | Count |
---|---|
103 | |
14 | |
10 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.