IDOC adapter Inbound Channel Connection Error in SM58

[Former Member]

Hi All,

I am facing the Error when i am trying to send IDOC form R/3 to PI .

Error: IDOC adapter Inbound Channel Connection Error (in SM58) .

Please help me to resolve this.

Regards

Upendra

[Former Member · Accepted solution]

Hi Upendra,

check these if following steps are done

In R/3 system:

1. create logical system using t-code BD54.

2 .assign the created logical system to the existing client using t-code SCC4.

3 . create RFC destination of type 3 pointing to PI system using SM59 t-code

4. create port give your own port name using WE21.

5. create the Partner profiles using WE20 in that the partner no will be the logical system name and under outbound parameters click on add button and maintain the Message type which you are sending to PI.

In PI system:

1. Create RFC destination of type 3 pointing to R/3 system.

2 . create Port using the IDX1 t-code port name should be SAP + SYSTEM ID OF R/3 system.

3. Using IDX2 import the IDOC meta data in to your PI system.

Also check https://www.sdn.sap.com/irj/sdn/weblogs?blog=/pub/wlg/1310. [original link is broken] [original link is broken] [original link is broken]

Regards,

Srinivas

[Former Member · Accepted solution]

Hi Srinivas,

I have checked all the setting as you menstioned , all are ok ,

I even i was checked SLD check and sldapicust transactions .

Regards

Upendra

[Former Member]

This issue resloved, it's due to the user dn't have SAP ALL authorization.

[Shabarish_Nair]

you need to verify your settings - http://wiki.sdn.sap.com/wiki/display/XI/SAPR3(Idocs)ToXI--Steps+Summarized

also check if the user used in the destinations have the proper authorizations. it should ideally be a rfc user

[Former Member]

Hi Shabarish,

Thanks for replay,

ALE settings properly configured ,and i have checked RFC destination with connection test and authorization test .

Regards

Upendra

[Former Member]

Hi Upendra,

Please check if the partner profile is maintained properly and the required message types are assigned as inbound and outbound.

If all connections are fine then you must be able to receiver/send IDoc's without the mentioned error.

Please check in IDX1 if port is maintained properly and you have give the correct partner number there for the sap system.

delete and load the meta data again for the related message type in IDX2

Run your scenario again and let us know if any issues.

Regards,

Srinivas

[rajasekhar_reddy14]

Hi Upendra,

Check you configurations once again,and refer below link

Regards,

Raj