cancel
Showing results for 
Search instead for 
Did you mean: 

How to enter individual defect and total defects for the same opeartion

Former Member
0 Kudos

Hi Gurus,

My client has a new requirement.

Currently we are entering results for an Chemistry operation with following characteristics.

Refusal Defects

AQL 0.10%

AQL 0.40%

AQL 0.65%

AQL 1.0%

AQL 4.0%

these characteristics are assigned with different sampling procedures with sampling schemes based on their AQL level.

But now my client wants to check each characteristics based on Individual defects ( 0.065 AQL) and Total permitted defects ( 0.25 AQL).

Please give your suggestions to map this scenario.

Thanks,

SDN.

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Just a suggestion can you not use same char twice with different sampling procedure which has differen AQL level.?

Former Member
0 Kudos

Hi Sujit,

Yes. I could think of it. Thank you.

Can we do anything through config or Master data set up to accomplish this?

Regards,

SDN.

Former Member
0 Kudos

Well its really not part of customization actually.

A AQL for a sampling procedure which is attached to a MIC

Answers (0)