on 06-18-2010 10:27 AM
Hello everybody:
When I enter in to a MM01 (material master data creation), and i chose a material type with an internal number asigment, the systmes gives me a number before I save it, so, if finally i don´t save the material, the next time I enter again into the MM01, the system will propose me the next number in the range, despite the last one, was never be saved, so the number remains unavailable in the system.
I.E
Get Mm01 and press enter, the system gives you this material number 3000001, but get out without save it,
the next time, you get back to the MM01, despite the 3000001 doesn´t exist, the system will propose you 3000002
Is there any way to avoid it?
Hi,
This cant be done in configuration
There are some enhancements for this control
You please check those enhancements
MGA00002 and MGA00003
regards,
santosh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanls mate, I will
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
11 | |
11 | |
6 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.