PM Work Order & Inspection Instructions simultaneous printing

[Former Member]

I'm trying to setup QM Inspection Instructions to print when PM Work Order prints. I tried 2 things so far:

in SPRO:

QM: Define Print Control, Forms, Print Programs - however, this section only deals with Order Category 50; a non-PM Order category. So I couldn't do anything here.

PM: Define Shop Papers, Forms and Output programs - here I tried setting up INSP_INSTRUCTION Form with Output program RQEEAS20, and it gives the following message: "ABAP form routine PRINT_PAPER in ABAP RQEEAS20 not found".

I was wondering if someone can point me in the correct direction of how to handle?

[Former Member · Accepted solution]

Hi ,

1. For PM the order category is 30 and application area is "O" .

2. You need to create a new FORM having QM Instructions details and mention that in a newly defined shop paper and mention the print programme .

3. You need to do the config as per below :

SPRO>PM>Maintenance and Service Orders --->Print Control .

You need to do the config under this node ..

regrds

pushpa

[Former Member · Accepted solution]

Thanks kolla pushpa, one more question. How can I print in QM with order type 30? (since the print settings are all for 50) What if I dont' want to automate, just to print?

Edited by: PMPSMM on Jun 16, 2010 9:25 AM